DAMPSOLV WHITE
A white cement modified Solvent based Acrylic Masonry coating that blocks water seepage and rising damp.
Recommended For
INTERIOR and EXTERIOR surfaces.
Used as a temporary protective coating to block moisture seepage and deter rising damp.
Not Recommended For
Not suitable for application over painted surfaces, or where there is a strong positive water pressure.
Also, not suitable for surfaces with excessive water problems.
NOTE: This is a temporary solution - the cause of rising damp and water ingress must be treated to achieve a permanent solution. Remember that if the moisture can’t
escape through its current channels, it will look for another way out the substrate and rear its head elsewhere.
Application
PLEASE NOTE: Correct preparation is essential. All surfaces must be sound and prepared in the recommended manner. For more information on surface preparation
contact your nearest Paintsmiths store.
Thoroughly stir and apply a minimum of 2 coats of Dampsolv to correctly prepared surfaces using a brush or roller at the stipulated spread rates. Allow to dry before
overcoating.
For best results it is important to remove all paint coatings to expose the raw plaster, concrete, or masonry and allow to dry fully before the application of Dampsolv.
Spread Rates
±4m2
/litre/coat
NOTE: The spread rates quoted are approximate and should only be used as a guide as the actual rate will vary depending on the condition and porosity of the substrate.
Enquire about this product.
Send us an enquiry and we will contact you as soon as possible.
