WB Non-Drip Enamel
An environmentally friendly, high quality, high sheen, Pure Acrylic water based enamel with excellent stain resistance and washability. It has excellent flow and levelling properties. It produces a highly washable, chip-resistant finish with non-blocking properties. For use on suitably prepped interior and exterior surface.
Recommended For
INTERIOR and EXTERIOR surfaces.
Used as a finishing coat on suitably primed new, or previously painted sand/cement plaster, concrete, fairfaced brickwork and gypsum plaster. Also ideal for suitably
primed asbestos, fibre cement, woodwork, primed metal surfaces and high traffic areas (e.g. walls in passages and walkways).
Not Recommended For
Not suitable for use directly onto gypsum plaster, or for use on floors or roofs.
Application
PLEASE NOTE: Correct preparation is essential. All surfaces must be sound and prepared in the recommended manner. For more information on surface preparation
contact your nearest Paintsmiths store.
After the correct surface preparation has been completed apply the necessary primer coat.
Then thoroughly stir and apply a minimum of two coats of Midas WB Non-Drip Enamel to the prepared surfaces using a brush, roller or spray at the stipulated spread
rates. Allow to dry before overcoating.
Spread Rates
±9m²/litre
NOTE: The spread rates quoted are approximate and should only be used as a guide as the actual rate will vary depending on the condition and porosity of the substrate.
Enquire about this product.
Send us an enquiry and we will contact you as soon as possible.
