Midacoat Satin
A hard wearing, Alkyd-Gelkyd, non-drip enamel that dries to a mar-resistant satin finish. Has excellent flow and levelling properties.
Recommended For
INTERIOR surfaces.
Used as a finishing coat for suitably primed and undercoated wood, metal and masonry surfaces as well as most previously painted surfaces.
Not Recommended For
Not really suitable for EXTERIOR surfaces.
Application
PLEASE NOTE: Correct preparation is essential. All surfaces must be sound and prepared in the recommended manner. For more information on surface preparation
contact your closest Paintsmiths store.
After the correct surface preparation has been completed apply the necessary primer coat.
Apply a minimum of two coats of Midas Midacoat Satin to prepared surfaces using a brush or roller at the stipulated spread rates. Allow to dry before overcoating.
When used on masonry surfaces, ensure the surface is thoroughly dry and correctly primed with a Midas Alkali Masonry Primer. Midas Midacoat Satin will appear
glossy on application and takes approximately 7 days to reach its final satin finish.
IMPORTANT: Do not stir before use unless separated. If so, stir well and allow to stand until the gel re-forms.
Spread Rates
± 8m²/litre/coat
NOTE: The spread rates quoted are approximate and should only be used as a guide as the actual rate will vary depending on the condition and porosity of the substrate.
Enquire about this product.
Send us an enquiry and we will contact you as soon as possible.
