PLEASE NOTE: Correct preparation is essential. All surfaces must be sound and prepared in the recommended manner. For more information on surface preparation contact your nearest Paintsmiths store. After the correct surface preparation, prime with the required primer, then stir thoroughly and apply Midas Midacryl to the substrate one primer / sealer coat of Midas Midacryl, diluted with 20% water and allow to dry (drying time is less than 1 hour at standard condition 25°C and 50% humidity). Apply one coat of Midas Midacryl as supplied, to an area not exceeding one metre by the width of the Polyester fabric used (Eramesh) and firmly press the fabric into the coating before the coating begins to dry. Repeat the process in one metre length at a time. Allow the application to dry before proceeding. (Drying time is 1 - 1 1 /2 hours at standard condition 25°C and 50% humidity). If the Polyester fabric becomes rain saturated, allow to dry out completely over an extended period before proceeding with the application process. Apply one coat of Midas Midacryl, diluted with 20% water, to penetrate and saturate the Polyester fabric (Eramesh) surface. Allow the application to dry thoroughly before proceeding. (Drying time is 2 hours at standard condition at 25°C and 50% humidity). Finally apply two coats of Midas Midacryl as supplied, allowing time to dry between coats. (Drying time per coat is less than 1 hour at standard condition 25°C and 50% humidity). All tests are performed at 23ºC and 50% relative humidity. Contact your nearest store for Technical Advice should you require any further information. Safety Datasheets are available on request. * This VOC value is determined on the untinted base. However, as Midas use ZERO VOC stainers for all their tinting, the VOC contribution from these is minimal and will vary from colour to colour.